Wrong Image Format for bootm command

[foneatics]

Hello,

I need some help urgently. I was looking for an embedded device to run as a pbx to control a door phone system and i found this project. I followed all the instructions and when trying to run i encountered the following:

U-Boot 2011.03 (Apr 26 2011 - 21:50:07)
Marvell-Sheevaplug - eSATA - SD/MMC

SoC:   Kirkwood 88F6281_A1
DRAM:  512 MiB
NAND:  512 MiB
In:    serial
Out:   serial
Err:   serial
Net:   egiga0
88E1116 Initialized on egiga0
Hit any key to stop autoboot:  0
Unknown command 'mmcinit' - try 'help'
** Bad partition 1 **
** Bad partition 1 **
Wrong Image Format for bootm command
ERROR: can't get kernel image!

How can i resolve this issue, any help would greatly be appreciated.

Thankxx

[PlugPBX Admin]

The error doesn't give me much direction.

Try and follow our all instructions closely. Depending on the SD card, you may want to 'zero' it before flashing (write zeros across entire device)

This can be as easy as ...

dd if=/dev/zeo of=/dev/your/sd/card/here/

Lots of suggestions and tools for win/mac/linux on the main website....

[foneatics]

Thanks for your response.

I did not bother to troubleshoot anymore i went ahead and use the roll out script and updated the links and it worked. I am, however looking for tools to resize the image because the card that i rolled out the image on is like 3mb more than the other card i have. Transend 4gb class 10 is bigger than the Transend 4gb class 6.

I was so happy that i actually went ahead and upgrade the kernel and uboot and installed snom ONE on it and it works like a charm. Next i am going to try asterisk 1.8 Free PBX 2.9 on the 3.0 kernel.
 

[PlugPBX Admin]

Cool. Be sure to report back and let us know how that combination works!!